TotalVPN - Windows 10     Total VPN

Knowledge Base

Windows 10

  1. In a browser, visit the Smart DNS page and whitelist your Windows 10 machine's IP address
  2. Click Start, then click Settings
  3. Click on Network and Internet
  4. Click the type of your connection then click Change adapter settings (Most likely Ethernet or WiFi)
  5. Right click on your connection and select Properties
  6. Uncheck Internet Protocol Version 6 (TCP/IPv6), then click Internet Protocol Version 4 (TCP/IPv4) to highlight it, then click Properties
  7. Click on Use the following DNS server addresses on the General Tab​
  8. Enter the DNS address which appears on the Smart DNS page, then click OK

After setting up TotalVPN DNS on your device, please reboot by turning on and off or restarting. You will then be fully configured to begin using SmartDNS services.​

Was this article helpful?

YES NO